What is an air filter? An air filter (or furnace filter) serves to stop dust, dander, and other particles from entering your furnace, and, by extension, from your air ducts and the rest of your home. The air that is moved by your heating and cooling system is circulated throughout your home several times a day. Housed in the filter compartment, and sandwiched between the end of the return duct and the blower compartment, the air filter keeps not only your HVAC system clean, but it also helps to keep your entire home clean by preventing contaminant buildup in the air ducts, which supply your household air. If your air ducts are dirty, some of that dirt necessarily will be contained in the indoor air you breathe daily. (Want to learn more about the process of air duct cleaning? Visit our air duct cleaning service page.) What options are available for air filters? The quality of air filters available varies greatly, and in general, you get what you pay for. A few different systems exist to rate the effectiveness of air filters, including MERV (Minimum Efficiency Reporting Value) and FPR (Filter Performance Rating). MERV, which is industry-established, tends to be the most widely used. FPR was established by the Home Depot, and its numbers align fairly closely with those of MERV. Both systems are straightforward: the higher the number, the more effective the filter (the smaller the particles blocked). Some of the common contaminants that air filters are tested for include lint, pet dander, dust, pollen, dust mites, mold spores, and bacteria. So which one should you buy? Well, the least expensive (often fiberglass) filters can be had for as little as 50 cents or a dollar. Pass these up. They are generally not recommended, as they block only the largest of particles, allowing an unacceptable amount of debris to pass through. This brings us to two interesting paradoxes of air filters:
What is “filter bypass” and what can be done about it? A common issue that technicians observe in the field that is quite detrimental but relatively easy to fix is referred to as filter bypass. This is when dirt and debris sneak around your filter and into the A-coil and the rest of your furnace, the air ducts, and consequently, your home. This often happens when an ill-fitting or cheap furnace filter is used, or, in some cases, improper installation of the filter rack. To prevent this, ensure that the air filter you use fits snugly into the filter compartment. If it is too small, air (and debris) will simply go around the filter instead of through it. In the case of improper installation of the filter rack, re-installation may be necessary to provide the proper fit. One of the telltale signs of filter bypass issues in an HVAC system are supply ducts that are as dirty (or almost) as the return ducts. The air that enters the return ducts is unfiltered (remember, the air filter is positioned at the end of the return duct, before it enters the furnace) and therefore the return ducts are expected to be dirty, but the supply ducts, when the air is properly filtered, tend to be much less dirty. And there you have it. With a system that is so essential to your family’s comfort, and that typically is costly to repair or replace, having a few common-sense nuggets of wisdom to prevent unnecessary maintenance can only be a good thing. Wanna dig deeper? Download our free tipsheet: 10 Questions to Ask Before Hiring an Air Duct Cleaning Company. Download Tipsheet Many thanks to our technician Ben S. for lending his expertise to this article.
0 Comments
|
SearchArchives
April 2022
|
Twin Cities Furnace Cleaning - Open 7 Days a Week 8AM to 8PM